Embossing Press: Grotnes 15S, Auto Feed, 12" x 14" Die, 600p/Hr., '77

Description

(1) Used ATLANTA/GROTNES Hydraulic Gap-Frame Automatic Embossing Press,
Model 15S, Job No. YO 1344, New 1977
--Upstroke-Design
Specifications:
Infeed Conveyor Height:............................................................ 27"
Minimum Part Width for Conveyor:................................................... 18"
Maximum Part Width for Conveyor:................................................... 23"
Infeed Conveyor Length:............................................................ 30"
Outfeed Conveyor Length:........................................................... 30"
Outside Post Distance:.................................................. 23" Front-Back
Built for Die Size of:............................................... 12" F-B x 14" L-R
Die Holder Size – Upper and Lower Platen:.................. 4 Dies @ 1" Wide x 12" Long
Die Center to Center Distance:.............................................. 1-3/4" R-L
Built to Run at Speeds Up To:......................................... 600 Parts / Hour
Hydraulic Pump Motor:........................................ 20 HP  230/460V  1750 RPM
Conveyor Feed Motor:................................................. 0.75 HP  230/460V
Equipped With:
Automatic Conveyor Feed
Electrical Pushbutton Controls for: Auto/Hand/Jog
Dual Tie-Rods in Front of Bed
**This machine was built to emboss numbers in 55-gallon drum tops.  It can be used as-is for the same project, or simply retooled and emboss anything**
**Drawings and parts are available from the manufacturer**
F.O.B.  Chicago, IL